Comment réparer un iPhone XR qui ne s'allume pas : guide de diagnostic et de réparation des courts-circuits.

When your iPhone XR won’t turn on, it can be frustrating — especially when there’s no visible damage. In this repair case, we’ll show you how a short circuit near the audio amplifier IC caused the iPhone XR to draw excessive current and fail to boot. Using professional tools like a DC power supply, rosin, and REFOX Bitmap, we accurately diagnosed and fixed the issue by replacing a faulty capacitor.

Whether you’re a repair technician, a DIYer, or a repair shop owner, this detailed guide will help you approach similar “no boot” cases with confidence.

Repair Case: iPhone XR Not Powering On

Upon receiving the iPhone XR, we connected it to a Alimentation en courant continu for diagnosis. The current draw was around 1A, indicating a possible short circuit on the board.

Since the current leakage starts immediately after connecting to DC power, we suspected a short on one of the following power rails:

• PP_BATT_VCC
• PP_VDD_MAIN
• PP_VDD_BOOST

The iPhone XR’s board structure is similar to that of older models like the iPhone 8 Plus. Based on experience, we can use either the rosin inspection method or a thermal imager to detect overheating components.

Before using any tools, we first applied a simple method: finger test while applying DC power. We felt unusual heat around the audio amplifier IC area.

To confirm, we applied rosin to the board and powered it again. The rosin melted directly on top of the audio amplifier IC, confirming heat in that area.

At this point, most would replace the audio amplifier IC. However, due to its proximity to the CPU, replacing it could risk Pseudo-brasage de l'unité centrale (a condition where CPU connections become unstable from heat exposure). Additionally, the audio amplifier circuit has multiple power lines, meaning a shorted capacitor could also be the cause.

Narrowing Down the Issue

Using this insight, we inspected the small capacitors around the audio amplifier IC. Sure enough, we located a shorted capacitor, as shown in the image (marked with an arrow in the original content).

By checking with the REFOX Bitmap, we identified this capacitor belonged to the PP_SPKAMP_TOP_VBOOST power rail.

Processus de réparation

We removed the faulty capacitor and tested the current draw again. The startup current returned to normal levels.

Next, we replaced the capacitor with one of identical specification. After reinstalling, the iPhone XR booted up normally.

We reassembled the phone and conducted a full function test — all features worked perfectly.

Pro Tips

• In this case, replacing a single shorted capacitor was enough to fix a severe no-boot issue.
• When multiple components feel hot, check small passive components (like capacitors) first.

Conclusion :

A no-boot iPhone XR might seem like a major failure, but with the right diagnostic approach, even complex issues like short circuits can be fixed efficiently. In this case, a careful inspection revealed a shorted capacitor near the audio amplifier IC, and replacing it brought the phone back to life. This repair highlights the importance of understanding circuit behavior, using boardview tools like REFOX Bitmap, and not rushing to replace major chips. If you’re in the repair business or enjoy DIY phone repairs, mastering these diagnostic techniques can save you time, reduce risk, and improve success rates.