Cómo reparar Huawei Mate X2 carga a humo y no puede arrancar problema

The Huawei Mate X2 is a cutting-edge foldable smartphone with an innovative design that pushes mobile technology to new heights. Due to a charging incident, the phone smoked, leaked current, and had a black screen, rendering it unusable. In this article, you will learn how to fix a damaged motherboard on a HUAWEI Mate X2 due to improper charging. This guide provides valuable insight into the repair process, regardless of whether you are a technician or a DIY enthusiast.

Detalles del teléfono:

Modelo: HUAWEI Mate X2

Anunciado: 2021, 22 de febrero

Fenómeno del defecto:

• The phone emitted smoke during charging and subsequently failed to charge.
• The screen turned black, and the phone could no longer be powered on.
• A diagnosis at a repair shop indicated motherboard damage, with a 10mA current leakage on the battery (BATT), preventing the phone from booting.

Solución de problemas

1: Initial Check:

• The phone was disassembled, revealing a motherboard that appeared new and had not been previously repaired.
• Connecting the motherboard to a Fuente de alimentación de CC revealed a 10mA current leakage.

2: Boot Attempt:

• The phone was assembled and an attempt to boot was made.
• The HUAWEI logo appeared briefly, then the screen went black again.
• Suspecting a battery detection issue, the battery was activated and tested again, but the phone still couldn’t boot.

2: Thermal Imaging

• The DC power supply showed current leakage, so a thermal imager was used to identify the overheated component.
• A small hole was discovered around the display connector under a microscope, indicating potential rail damage beneath the surface.

Even though it’s only a very tiny hole, it’s a serious problem, as the underlying layers with many rails are broken.

Proceso de reparación

1: Damage Assessment:

• The connector was removed to assess the extent of the damage.
• The small hole revealed deeper damage than initially expected, with multiple PCB layers likely affected.

2: Repairing Broken Rails

• The surrounding shielding covers were removed to access the damaged area.
• The PCB layers were carefully scratched away using a blade knife to expose the broken rails.
• Around 3-4 layers of rails were found to be broken.

3: Jumping Wires

• A UV mask was applied to cover the grounding rail layer.
• Wires were jumped across the broken layers, ensuring each rail was connected to its correct destination without causing shorts or bridges.
• This delicate process took approximately an hour to complete.

4: Reassembly and Testing

• The connector and surrounding components, such as small capacitors and resistors, were soldered back onto the board.
• The phone was reassembled and connected to the DC power supply.
• The current leakage was no longer present, and the phone successfully booted up.

Tips for Prevention

• The issue may have been caused by using a poor-quality charger or charging cable.
• To avoid similar issues, it’s important to use reliable and scientifically tested charging methods to keep your phone safe.

Conclusión:

The Huawei Mate x2 charge to smoke, and it cannot boot or turn on isn’t normal, but it does happen occasionally. REWA Tech wrote this article based on a case study. This tutorial is intended to help repair technicians and DIYers learn something new.